Proface APL3000B - Node Box PC Manual do Utilizador Página 1

1PL-3900T SeriesInstallation GuidePackage Contents(1) PL Unit (1)(2) Installation Guide (1) <This Guide>(3) Warning/Caution Information (1)(4) I

10 RAS Interface• Be sure to use only the rated voltage level when using pin #1 (+12V) for external power output. Failure to do so can lead to a unit

11(2) Confirm that the installation gasket is attached to the PL unit and then place the PL unit into the panel from the front.• It is strongly recomm

12(4) Slide the control box in direction shown by the arrow.(5) Lift the control box and remove the front module tabs from the slot on the installa-ti

13CA7-ACCNL-01 of Pro-face or FKC 2,5/3-STF-5,08 of Phoenix ContactDC type : CA7-DCCNL-01 of Pro-face orGFKC 2,5/3-STF-7,62 of Phoenix Contact Connec

14device, be sure that the design of the system/connection does not produce a shorting loop.• The grounding wire should have a cross sectional area gr

15face of the holder, twist the USB Cable Clamp’s band around the USB cable, pull the band in the direction of the arrow, and then fasten the band usi

16PL's Front ModuleNotes:1. Nonincendive Circuit Parameters: Front USB I/F:Voc = 5.0 V, Isc = 1.25 A, Ca = 10 µF, La = 16 µH2. Selected Associate

2Part Names and FunctionsName DescriptionAPower LED / RAS status lamp (POWER)B Disk access lamp (DISK)CFront cover —DHardware reset switch (RESET)Rese

3Name DescriptionF DVI-I interface (DVI-I) For analog RGB output only.*1*1 DVI monitor cannot be connected.GEthernet interface (LAN1)10BASE-T/100BASE-

4• When attaching peripheral units to the PL, be sure the PL’s power cord is disconnected from the main power supply.General Specifications Electrica

5 Environmental Specifications• When using any of the PL’s optional devices, be sure to check that device’s specifica-tions for any special condition

61. Internal switches of the control box System Set SwitchSwitch LocationSwitch NameCompati-ble I/FFactory SettingsDescriptionSW1 System Set Switch –

7 Serial Mode Select SwitchSwitch No.Description ON OFFRS-232C RS-422 RS-4851Internal settingReserved Reserved OFF*1*1 Be sure to keep the settings O

8Serial Mode Select Switches (SW4 to SW10) operate as shown in the circuit diagram below.*1 Refer to *2 on the previous page.2. Internal switches of t

9External Interfaces• Always connect the #5 SG (Signal Ground) of the PL unit to the con-nected device, especially if the con-nected device is also no