Proface LT3300 - 5.7 All-in-One HMI" Manual do Utilizador Página 1

1LT-3200 SeriesInstallation GuidePackage Contents(1) LT Unit (1)(2) English and Japanese Installation Guides (one of each) <This Guide>(3) Warni

10(4) Remove the flathead screwdriver from the tool insertion hole (square-shaped hole). The wire insertion hole (round-shaped hole) will close and t

11• The power connector (plug) is CA5-DCCNM-01 made by Digital Electronics Corporation or MSTB2,5/3-ST-5,08 made by Phoenix Contact.When connecting th

123. Grounding Cautions• Be sure to create an exclusive ground for the Power Cord’s FG terminal. Use a grounding resistance of 100Ω, a wire of 2mm2 or

13• To prevent malfunctions due to noise, communication cables must be wired separately from high-frequency lines and power lines such as high-voltage

14Installation prerequisites for standardsFor the detailed certification's information, refer to the Pro-face Home page.<Cautions>Be aware

15CE Marking• LT3201-A1-D24-K/LT3201-A1-D24-C units are CE marked, EMC compliant prod-ucts. For the detailed information, be downloaded and refer the

2Part Names and FunctionsName DescriptionAStatus LEDB AUX Interface (EXT2)Used to connect the additional units (communication function etc.).C EX Modu

3General Specifications Electrical Specifications Environmental SpecificationsPower SupplyInput Voltage DC24VRated Voltage DC19.2 to 28.8VAllowable

4DIO Interface (Connector)• When preparing the cable to connect the wiring, check the pin numbers inscribed onthe DIO Connector.• Parenthesized signal

5Input DeratingUsing LT input voltage that exceeds the rated voltage, the input ON voltage, the number of input points or the LT’s temperature can ef

6 Output Specifications LT3201-A1-D24-K Output Circuit (Sink type)• Since the output terminals are not electrically protected, an output line might

7 LT3201-A1-D24-C Output Circuit (Source type)• Since the output terminals are not electrically protected, an output line might be short-cir-cuited o

8Installations1. Installation Requirements• For easier maintenance, operation, and improved ventilation, be sure to install the LT at least 100 mm [3.

9• Tightening the screws with too much force can damage the LT unit’s plastic case.• The necessary torque is 0.5N•m.• Be sure to insert installation f