Proface GP4100 - 3.4 Compact HMIs" Manual do Utilizador descarregar pdf (Página 54)

Chapter 4 Installation and Wiring

4-9

(4) Use a flat-blade screwdriver to tighten the appropriate terminal screws on the terminal connec-

tor from step 3.

• Use a flat-blade screwdriver (Size 0.4 x 2.5) to tighten the terminal screws.

The torque required to tighten these screws is 0.28N•m

(2.5 [Lb

•

in])

• The power connector cannot be removed because it is mounted to GP unit. Do not

attempt to remove or tamper with the power connector. It may damage the power

connector.

• Be sure to loosen the terminal screws before pulling out the power cord. The power

connector may be damaged by pulling the power cord when attached to the power

connector.

• Do not solder the cable connection. Doing so may damage the unit due to abnormal

heat or cause a fire.

• Be sure to twist the power cords together, up to the power connector.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 68 69

Sem comentários

Proface GP4100 - 3.4 Compact HMIs" Manual do Utilizador Página 54