Proface APL3000B - Node Box PC Manual do Utilizador Página 1

1PL3000 Series Installation Guide(Built-in Battery Unit Version)Package Contents(1) PL Unit (1)(2) English and Japanese Installation Guides (one of ea

10• When using the display unit with a cable other than FP-DV01-100 (such as FP-DVD01-50), use the Factory Setting.• The default Resolution and Screen

11Backup Battery1. About the BatteryThe battery unit is equipped with a Ni-H battery for backup. Charging timeIt takes 15 hours for the battery to be

12• Avoid leaving the battery in high tem-perature places such as direct sunlight, inside a sun-heated car, near water, or near a heater. Doing so ma

13COM1*3 To change the communication method, set the DIP switch located on the circuit board in the PL unit to the desired position.For details, see

14Installations1. PL-3000B Series Installation Installation Requirements• For easier maintenance, operation, and improved ventilation, be sure to ins

15 Installation• Determine the thickness of the board in consideration of its strength. The mini-mum thickness of a board is 1.6 mm [0.06 in.] for M4

16• Tightening the screws with too much force can damage the PL unit.• Be sure to insert installation fasteners in the recessed portion of an installa

17unit without adjusting the Panel Cut size. As shown in the following diagram, simply remove 7 screws from the upper and lower positions to remove at

18• Tightening the screws with too much force can damage the PL unit.• The torque required to tighten these screws is 0.8 N•m.Installation/uninstallat

192. Installation/uninstallation of the front module and the control box (PL-3600K/3700*/3900T Series) Uninstalling(1) Unscrew the two attachment scr

2Part Names and FunctionsName DescriptionAPower LED / RAS status lamp (POWER)BDisk access lamp (DISK)CFront cover —DHardware reset switch (RESET)Reset

20 Power ConnectorThe following parts are used in the power connector (plug). When PL is mounted vertically, a right-angle power connector is recomme

21• To improve the noise resistance, be sure to twist the ends of the power cord wires before connecting them to the Power con-nector (Plug).• The PL

22Connecting USB Cable Clamp Attaching the USB Cable Clamp(1) Place the PL unit face-down on a flat sur-face as shown below. Your PL unit has four US

23 Built-in battery unit and DVD unit ver-sionFor the detailed certification's information, refer to the Pro-face Home page.<Cautions>Be a

24

3Name DescriptionH DVI-I interface (DVI-I)Interface with DVI monitor or analog RGB monitor. DVI monitor can be connected to PL-3000B series only.IEthe

4W Fan cover System fan insideX System fan A fan for cooling the PL unit.Y Power connector —Z Power switch —a Switch coverRemove switch cover when set

5General Specifications Electrical SpecificationsPower SupplyAC typeInput Voltage AC100 to 240VRated Voltage AC85 to 264VRated Frequency 50/60HzAllow

6 Environmental Specifications• When using any of the PL’s optional devices, be sure to check that device’s specifica-tions for any special condition

7• Make sure to turn off the power supply before using the switches. Adjusting the switches while power is supplied may cause errors.1. Internal switc

8 System Set Switch Serial Mode Select SwitchSwitch No.Description ON OFFFactory SettingsNotes1 Internal settingReserved ReservedOFFDo not change. (

9 DVI Cable Selection SwitchWhen connecting Pro-face FP3000 Series to PL-3000B series unit, use the Pro-face DVI-D cable (10m) FP-DV01-100. (Other 10