Proface APL3000B - Node Box PC Manual do Utilizador descarregar pdf (Página 38)

Chapter 2 Specifications

2-11

 Switches

The following switch settings corresponding to each Serial Interface need to be signified. To set the switches

which are on the PS-A’s circuit board, remove the PS-A’s Rear Cover. Please refer to "3.2.1 Removal/

Attachment the Rear Cover" (page 3-6). The switches are located as follows;

Switch

Location

Switch Name

Compatible

I/F

Factory

Settings

Description

A Serial Mode Select SW COM3

All OFF

(RS-232C)

10-point dip switch. Designates COM3

communication settings. For Serial Mode

Select SW details, see Table (2).

B System Set SW -

See

Table (1)

10-point dip switch. For System Set SW and

the factory settings details, see Table (1).

C RI/+5V Changeover SW COM1 RI Changes # 9 pin (RI <---> +5V).

D RI/+5V Changeover SW COM2 RI Changes # 9 pin (RI <---> +5V).

Touch Panel's Communication

Changeover SW

COM4

USB

Changes the Touch Panel communication

method. (Serial <---> USB)

(If “Serial” is selected, COM4 cannot be used.)

123456789

5V RI 5V

USB RS232C

Inside of the rear

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 110 111

Sem comentários

Proface APL3000B - Node Box PC Manual do Utilizador Página 38